Waterboost Hydrogen Engine



Uploaded by: waterboost
Video Description:
A small briggs and stratton running on hydrogen and oxygen from an ondemand electrolysis unit. The video was done on a phone (Quality Poor)... The engine is started on petrol, the petrol immediately switched off... it takes over 1 minute for the petrol to run out and the pure gas (HHO) from water takes over... Mmmm, super smooth, quiet, no fumes... Just got to make more gas to run the car!
INSTRUCTIONS: Leave the carb as it is.... Take the air filter off and fit a face plate to attach your new inputs on... You want in air in tap for running on petrol and a gas in tap for the HHO The HHO needs a really small tube to carry it as close to the intake inside the engine as u possibly
can to keep a pressure as it enters the manifold... And thats it! ;) Start her on fuel and count how long it takes for the engine to rev lean as it runs out of fuel...Our little Briggs motor took approx 27 seconds to run out of fuel, so as soon as it goes waaeer! Tunr off the air intake tap and sl
owly start to add the HHO... Keep your eye on the HHO, you dont want to allow to much gas to flow, you need to maintain system pressure... As you hear in the video, the engine then settles in for another 30-40 seconds, this is the last 2 seconds of fuel being stretched out by the HHO... Then the en
gine note changes again into super quiet mode, the fuel has run out! WHack the HHO tap on full and thats it! Once it is happy you can then tweak the air mixture tap to get more power... A good strong stainless bubbler is an essential safety device and if necessary a secondary gas chamber to allow
a small buffer stock of gas in the system (Depends on your electrolyser setup) We used a car battery for power but if you have one, a tig welding power supply will give more control over the gas production rate so you can match it to the motors needs... We had to keep adjusting the electrolyte mix
until we got a nice steady 30amps...


Tags for this video: browns car environment fuel gas hho hydrogen water waterboost

Find more videos in the "Howto" category
See more videos uploaded by waterboost

Related Videos
Water4Fuel #12 Hydrogen Gas - Cell ExplosionHydrogen Powered Small EngineBMW Hydrogen engine
water4fuel-12-hydrogen-gas-cell-explosion.htmlwater4fuel-12-hydrogen-gas-cell-explosion.htmlwater4fuel-12-hydrogen-gas-cell-explosion.html
Make HydrogenHydrogen Fuel Cell with 5 plates. installed in car!Hydrogen FX Cells running 2HP engine on HHO 5.5 liters
water4fuel-12-hydrogen-gas-cell-explosion.htmlwater4fuel-12-hydrogen-gas-cell-explosion.htmlwater4fuel-12-hydrogen-gas-cell-explosion.html


Share This Video:       StumbleUpon       del.icio.us       Reddit       digg       Furl       Spurl       Simpy       YahooMyWeb


Comments for this video: Show || Hide
Comments for this video on YouTube
what cylinder? we ... ( 6 months ago by waterboost)
what cylinder? we are making it as we are using it? The unit is strong enough to take a full explosion at 6psi... and makes a hard thud and you see light... but its safer than pharmacutical medication!
OK, I get it now. ... ( 6 months ago by Galakas)
OK, I get it now. Thanks for getting back on this. I wrongly assumed that the red cylinder in the background was supplying your HHO. Keep up the good work, its very interesting!
what size orifice ... ( 6 months ago by BillyJackets)
what size orifice did you use at the intake please?
at which point? ... ( 6 months ago by waterboost)
at which point? thats a sketchy question...
it is very quiet , ... ( 6 months ago by leviterande)
it is very quiet , I am not expert in this area but the other normal combustion engines I have seen that made work on hydrogen sounded as usual with gasoline fuel, nowhere as quiet and magical as this? Thanx keep up the nice stuff running:D kalle
I belive the engine ... ( 5 months ago by atr69x)
I belive the engine is running quiet due to lack of HHO. The engine is running a slower RPM than idle and has very little power. Need to ramp of the HHO production.
It isnt slower ... ( 5 months ago by waterboost)
It isnt slower until it slows down... it had plenty power and no flywheel... I do need to have another play with it but I have been a bit busy...
All questions ... ( 5 months ago by Hiei2k7)
All questions involving an orifice are kinda sketchy, right? ;-) I believe Mythbusters did the same thing with compressed hydrogen and a GM 305, so It can be done with carburated engines already in existence. Now we need to produce mass amounts of the stuff.
I can easily make ... ( 5 months ago by waterboost)
I can easily make 20,000 litres but where do I put it?
hmm. Regular gas ... ( 5 months ago by Hiei2k7)
hmm. Regular gas tank? Retrofit the carburetor with backfire retarder and you're good to go.... Remember: I make replies on the fly, so DO NOT ATTEMPT THAT AT HOME unless you've studied into it, and if you have, and it works, How much to retrofit my truck here in Arkansas, where Gas is currently $3.80/gallon?
$3.80... Thats ... ( 5 months ago by waterboost)
$3.80... Thats cheap as f@@k we pay
£1.30 per litre... Thats over $2 per litre... double what you guys pay
We've been used to ... ( 5 months ago by Hiei2k7)
We've been used to $.75-$1.50/gallon fuel for so long though.
Do you know how ... ( 5 months ago by gibsonrockin247)
Do you know how much 20.000 litres is? Ya right
yeh! funking loads. ... ( 5 months ago by waterboost)
yeh! funking loads... its about 20,000 litres worth... It would be a big bag of boom!
Is Hydrogen a ... ( 5 months ago by surrealdirector)
Is Hydrogen a viable alternative fuel for cars? ...I do know that hydrogen can be easily produced, using solar and wind power for electrolysis of water. !!!
Dont forget the ... ( 5 months ago by waterboost)
Dont forget the oxygen... conventional electrolysis makes hydrogen and oxygen seperately... then the oxygen is usually exhausted??? Common duct hydrogen and oxygen is a far more powerful fuel but it cant be stored, it has to be used... hydrogen and oxygen on demand...
Are you saying it ... ( 5 months ago by surrealdirector)
Are you saying it wouldn't be worth the trouble to have a wind turbines induce electrolysis, resulting in reservoirs of hydrogen and reservoirs of oxygen? Do you have a website for additional info?
cool until you ... ( 4 months ago by trevor22333)
cool until you crach and blow up the tank! ya look up Hydrogen bomb!!
What Tank? You ... ( 4 months ago by waterboost)
What Tank? You retard! You just dont get it do you? Its water... then HHO... then it gets used... Have you read any of the 68 comments or the description at the top?
Excuses excuses... ... ( 4 months ago by atr69x)
Excuses excuses... "It isn't slower until it slows down"? What kind of stupid reply is that? It slowed down! Why did it slow down? I answer: Barely enough fuel to maintain idle. Not enough production for any kind of throttle! Get back to work and increase the HHO output! And keep up the good work. ;)
I was using a tap, ... ( 4 months ago by waterboost)
I was using a tap, not a thread valve... it was easy to waste gas, but there was plenty... The gas machine was poorly as it happened... someone used alloy rivets inside!
I'm using injectors on my next project... a 650cc KLR! My research has been directed towards seals... waterboost packaging is done...
Injection, now were ... ( 4 months ago by atr69x)
Injection, now were talking! Can't wait.
You can not do this ... ( 3 months ago by waterboost)
You can not do this with jam jars... no matter how many spirals and how much glue...
Dont buy plastic rubbish... or jam jars with stainless wire.
how many volts are ... ( 3 weeks ago by scottman12)
how many volts are you using i made a generator and it was using i think 160 amps when tested at the auto electrician and he said if i bump up the volts cause i was going to use it in my 24 volt truck. 24 volts would use half the amps so my question is what is the best mix of volts to productivity and how much hho would i need to run a 13 hp on a 5 kva generator to acually make a resource that will save money and in areas with no power it would change peoples lives from water.



Tell a friend:


URL 
Embed Code 



Tips to help you create better videos

1. Eye Candy.
Think about some of your favorite videos, ask yourself, what interesting shots and b-roll need to be captured to make your video entertaining to watch.

2. Good Lighting.
The main difference between amateur and professional videos is the quality of the lighting. Poor lighting creates graininess and poor quality videos too. (*Hint* In most studios, the lights and the cameras can be adjusted up and down to get the correct amount of light.) For your home studio make use of fluorescent light bulbs. These bulbs produce a nice soft light with no harsh shadows. You can buy fluorescent light kits or you can save a lot of money and make your own fluorescent light box. It is best to use a three point lighting system which is fairly standard in most studios.

3. Tripod.
Use a tripod for shake free shooting. Tripods come in all sizes and quality. Most camcorders used today are only small and weigh very little so there is no need to buy a tripod to suit a heavy professional video camera.

4. Microphone.
The built in microphone on your camcorder is not the best to use if you can avoid it. Buy a directional one that can be mounted on top of your camcorder. Otherwise mount the microphone on a boom or support just out of view of the camcorder but close to the subject. Another option is to use a microphone that clips onto your lapel and as used by newsreaders on television. These are very effective and can be purchased for less than $50. No need to buy a wireless unit, but you need enough cable to run from the camcorder remote microphone, up the inside of your shirt and to your lapel. Bear in mind that you will normally be seated within six feet of the camcorder so the microphone should have plenty of cable.

5. Avoid Zooming and Panning.
Avoid zooming in and out and panning from side to side as much as possible. It is recommended that you set the zoom prior to recording.

6. Pre-Roll and Post-Roll.
Allow a few extra seconds after starting and before stopping the camcorder and the actual start and finish of the action you want to record. This allows for better editing once the shooting is over. Not allowing for the pre-roll and post-roll can make editing difficult. If you are filming yourself then start the camcorder recording with the remote control, wait six seconds before you start talking and at the end let the camcorder run an extra six seconds before stopping. This will give you plenty of time when editing.

7. Remember It is A Small Screen.
When shooting videos to add to your web site, normally the player will be 320 x 240 so avoid wide scenes, keep it close to see the detail. If you are filming yourself talking, you should be within six feet of the camera and preferably from the waist up. Keep the content simple and uncomplicated, do not have much happening in the video and keep it quiet-on-the-set.

8. Think Like a Photographer.
When shooting a video, do it like a photographer taking individual shots. Plan your video shoot, record for a short while from one position then stop recording, reposition the camera or yourself then shoot again. This will reduce excessive camera movement in your video. Using these tips will ensure that you can shoot and produce quality website videos of a better quality than most people. Remember, practice makes perfect and soon you will be getting great results on the first take.

9. Look at the Details.
Sometimes, you are so focused on your subject that you do not notice the surrounding elements of the scene. Only later, when you are reviewing the footage do you notice an unsightly trash can in the background or a tree sticking out of your subjects head. I like to scan the video screen carefully before shooting to make sure there is nothing in the shot that I may have overlooked. You may be surprised what you find!

Use our search feature, at the top of the page, to find videos about your favorite topics. There are tons of videos, for example, type in "Bikini contest", "Body building", "Guitar lesson", or "How to (anything)". Search for "Commercial", you will see cool ads and funny commercials. Notice the video techniques used to capture each video, you may very well find many helpful tips and tricks to use as well as many techniques to avoid when making your own videos... have fun.